Common sense of concealed pipe detector
Release time:
2024-05-25
The hidden tube detector is a high-tech product, which can help us detect some invisible hidden dangers. We need to pay attention to the following points when using it. Before using it, we must first clean the probe of the hidden tube detector to avoid errors. During use, we must avoid other electromagnetic interference, such as mobile phones, computers, etc., as far as possible away from the hidden tube detector. When using the hidden tube detector, we need to operate according to the instructions and set different modes and sensitivity according to the specific conditions, after the use of timely maintenance, to ensure that the next use can still work normally, in use, follow the relevant safety procedures, to avoid improper operation caused by their own injury, can let us know more about the surrounding environment, but in use must pay attention to safety, to avoid any problems.
The hidden tube detector is composed of two parts, namely the basic definition of metal detector and automatic rejection. Usually, the metal detector is composed of metal detector and automatic rejection device. The detector is the core part. There are three groups of coils in the detector, namely the central sending coil and two equal pick-up coils. The oscillating device of the vibrating metal detector connected with the sending coil generates a high-frequency variable magnetic field. In the idle state, the induced voltages of the pick-up coils on both sides cancel each other out before the magnetic field is disturbed, thereby reaching a balanced state. Once metal impurities enter the magnetic field area, the magnetic field is disturbed, and this balance is broken. The induced voltages of the two pick-up coils cannot be offset. The induced voltage is amplified by the control system and an alarm signal is generated (metal impurities are detected).
The hidden tube detector can use the alarm signal to drive the automatic rejection device to remove metal impurities from the production line. The relevant vocabulary drop metal detector is generally equipped with an automatic rejection device, so it is customarily called a drop metal detector or a metal detector. The metal detector requires that the product cannot contain metal. However, considering the high requirements of sealing performance and light avoidance, the metal composite film must be used for packaging. The metal itself is metal, therefore, if a channel metal detector is used, the detection sensitivity will be greatly deviated or even undetectable.
In view of the above reasons, you can choose to test before packaging. The falling metal detector is developed for the above situation. It is mainly used to detect tablets, capsules, particles (plastic particles), etc., and powdery items. When these items pass the falling metal When the detector falls, once metal impurities are detected, the system immediately starts the separation mechanism to eliminate suspicious items, the pipe detector has the characteristics of simple installation, high sensitivity, convenient maintenance, high efficiency, stability and reliability.
The dark tube detector has the following characteristics: the dark tube detector can detect all kinds of particle radiation, including X-ray, gamma ray, neutron, etc., and has high detection efficiency. Due to the special structure of the dark tube, the ionized gas can discharge quickly inside it, the response time is short, and the signal can be sent out in time.
Able to withstand higher doses: the gas and structural materials inside the dark tube can withstand higher radiation doses, and at the same time has a good protective effect. It can amplify the detected signal, reduce the clutter signal interference, and improve the signal-to-noise ratio. It is widely used in nuclear physics, astrophysics, cosmic ray research, medical radiation diagnosis, industrial non-destructive testing and other fields.
We sincerely look forward to working with you!
E-mail:
Telephone:
Address:
Room 302, Building 9, Daijiashan Science and Technology Venture City, 888 Hanhuang Road, Jiangan District, Wuhan City
Copyright©Wuhan Jie Tan Technology Co., Ltd.